So you have a Baby Bee or Black widow?

How do you use our Slickmount?!?

Well, we now have conversion kits to change the Cox Baby Bee and the Black Widow to a format that will work with our standard Slickmount. This will extend the run time to about 15 to 20 minutes and actually make it run better.

Back to Slickmount page

This is the Killer Bee back assembly designed for the Black Widow engine.

Cost: $7.80

 

Shipping is free when ordered with an airplane kit or $3 plus $1 each additional item in USA and Canada

Note: when using the U-Shop shopping cart, shipping charges are all messed up! Your actual cost should be less and will be billed based on shipping charges shown above.
This assembly will allow you to turn your Black Widow into a Killer Bee with the reed valve back shown above. The swap only takes a couple minutes and our kit includes the necessary screws, needle valve and a new reed. After the swap, you will be able to bolt your engine up to our original Slickmount.
This is the standard reed back assembly designed for the standard Baby Bee engine

Cost: $6.25

 

Shipping is free when ordered with an airplane kit or $3 plus $1 each additional item in USA and Canada

Note: when using the U-Shop shopping cart, shipping charges are all messed up! Your actual cost should be less and will be billed based on shipping charges shown above.
Our kit will supply the necessary parts to convert your Baby Bee engine for mounting to our Slickmount. We hear over and over again how well this combination works for small planes. So don't give up because you have an engine with it's own tank--just convert!

Go back to Slickmount page